Pagoda Shape Octagonal Candlestick Candle Mold, Pointed Long Pole Dining Table Wedding Plastic Pc Acrylic Mold

Product size: 518cm Wearing wax core tutorial 1. First, align the cotton thread with the bottom of the mold 2The cotton thread passing through the small hole opens to the mold The small holes are inserted into the mold from the outside to the inside. Pull it out, & leave 3~4 cm in length. 3. Leave 2~3 cm of the cotton thread at the bottom of the mold 4. Use glue to stick the small holes at the bottom of the mold, Length, the rest is subtracted. Avoid leaving the hole when pouring wax liquid later. 5. Pass the cotton thread at the opening through the wax core holder 6. Straighten & tighten the cotton thread to the extent that the wax core holder will not shake Candle making flow chart 1: Put the cotton thread or candle wick through the mold & fix it up & down 2: Put the wax into the pot & heat it to about 100 degrees 3: Drop a few drops of your favorite essential oils & colors (must be oily essences) 4: After the wax has melted, pour in about 0.5-1cm of wax & wait for it to solidify (about 5 minutes) to seal the bottom 5: Pour the wax again (cold shrinkage will occur during the cooling process, the remaining wax can be heated to 110-120 degrees in the recessed area & then added, & the leveling is repeated several times) 6: Cut off the excess part of the candle wick & wait (about 1-3 hours, if there is a wire, please unplug the wire first) 7: After cooling, the mold can lightly hit the table top to shake the candle inside, open the mold, & move to the lid. That is, the big end is squeezed by hand, & the candle is poured out, & your result is successful! Courier chooses registered courier from various places, the time limit is generally about 10~20 days Due to the impact of the epidemic, express delivery may be slower, please understand & thank you. If you have any questions, please contact: luowenjun2018@outlook.com Pagoda Shape Octagonal Candlestick Candle Mold, Pointed Long Pole Dining Table Wedding Plastic Pc Acrylic Mold